This is not a tax exempt website.
All Government Agencies, please contact customer service at 800-541-9719 ext. 1
N71 - Pre-Inked Insert for Spin 'N Stamp 1/2" x 1-5/8"
N71 - Pre-Inked Insert for Spin 'N Stamp
1/2" x 1-5/8"
SKU:
N71
| Pre-Inked Insert for Spin 'N Stamp - Impression Dimensions: 1/2" x 1-5/8" |
This size is great for small return addresses. This is a single insert for your Spin 'N Stamp. This stamp case can hold 3 of these inserts. Great for offices with multiple locations. The laser engraved rubber makes this stamp strong and durable for years of use. Makes approximately 50,000 impressions before re-inking is needed. Use Xstamper Refill Ink only. Use of any other ink will void out the warranty.
Re-Inking Instructions: With bottom facing you:
1. Hold the dial tightly so it does not move and slide out the rubber stamp cartridge.
2. Place 3 to 4 drops of ink into the channel.
3. Slide in cartridge along the rails until the cartridge clicks into place.
4. Be sure to insert cartridge into holder starting with the double slots side first.
*If spillage occurs on hands during re-inking, wipe with rubbing alcohol and wash with soap and water.
Recommendations: Re-ink your stamp overnight standing upright to prevent leakage and to allow the ink to fully absorb into the stamp pad.
|
Recommended Uses:
Multiple Address Locations
Multiple Names or Phrases
|
Features:
Xstamper (Oil Based) Ink
Xstamper Lifetime Warranty
|
|
©1999-2024 Connectweb Technologies, Inc.