This is not a tax exempt website.
All Government Agencies, please contact customer service at 800-541-9719 ext. 1
F30 - Industrial Xtra-Large Inspection Stamp 1-3/16" Diameter
F30 - Industrial Xtra-Large Inspection Stamp
1-3/16" Diameter
SKU:
F30
| Industrial Xtra-Large Inspection Stamp - Impression Size: 1-3/16" Diameter |
Make your mark almost anywhere with the pre-inked industrial stamps by Xstamper. Our proprietary ink formulation is fast drying, permanent and water-resistant when fully cured. The uniquely designed caps are engineered to keep ink from drying out. These stamps are ideal for marking on any slick or hard to mark surfaces.
*Average drying time for the "F-Series" stamps is around 90-120 seconds but may vary due to atmosperic conditions.
Must Use Xstamper's Industrial Refill Ink only.
Re-Inking Instructions:
1. Unscrew cap and hold handle vertically. Use bottom of cap to remove the die holder.
2. Insert bottom of cap into die holder and turn handle counter clockwise to remove the die holder.
3. Place 25 drops of Industrial Refill Ink into the opening.
Recommendations: Re-ink your stamp overnight to allow the ink to fully absorb into the stamp pad.
Works on the following Surfaces with Results: |
A.B.S (Excellent)
Acrylic Board (Excellent)
Aluminum (Excellent)
Brass (Excellent)
Cellophane (Excellent)
Ceramic (Good)
Cotton Cloth (Excellent)
General Painted Surfaces (Excellent)
Glass (Good)
Hard & Soft P.V.C. (Good)
Leather (Good)
Melamine Coated Board (Good)
Plywood (Good)
Polyester Film (Excellent)
|
Art Paper (Excellent)
Coated Paper (Good)
Construction Paper (Excellent)
Corrugated Paper (Excellent)
Hard & Regular Tracing Paper (Good)
Letter Paper (Good)
Photographic Paper (Excellent)
Polyethylene Film (Fair)
Polypropylene (Good)
Rubber (Fair)
Stainless Steel (Excellent)
Styrofoam (Good)
Synthetic Fabric (Good)
|
|
| |
"Satisfaction Guaranteed
©1999-2024 Connectweb Technologies, Inc.